You can see on our website, we provide the WIC RESET UTILITY program so you can solve this error on your own when the Waste Ink Counter come back to 0%, the printer will go on working. Please contact Epson Support”.įor the new Epson printer series, they install the Waste Ink Counter on 100% position before the Epson Stylus NX400 printer’s Waste Ink Pad is full of waste ink and the Waste Ink Counter raises up. The Epson Stylus NX400 printer will stop working immediately when this case happens to avoid the waste ink overflowing, the printers can send you the signals of this error such as the red lights blinking as well as the message on the screen: “The Printer’s Ink Pads are at the end of Their service life. After a long period of printing documents, the Waste Ink Counter will gradually raise up from 0% to 100%. This is used to calculate the number of waste ink during printing procedure. The manufacturers produced the printers with an important component called Waste Ink Counter. I hope this will help.The users who use the Epson Printer series all have the problem while the printing process is happening, this issue called Waste Ink Counter Overflow. When you see a completion message on the LCD display screen, ink charging is finished. 9 Once you replace all the necessary cartridges, close the cartridge cover and push it down until it clicks into place. 8 Insert the new cartridge into the holder and push it down until it clicks into place. 7 Remove the yellow tape from the bottom of the cartridge. (Do not shake a cartridge after opening the package ink may leak.) 6 Remove the cartridge from the package, but be careful not to touch the green chip on the cartridge. 5 Before opening the new cartridge package, shake it four or five times. Squeeze the tab on the cartridge and lift the cartridge straight up to remove it. Then select Change Ink Cartridge and press OK. If you’re replacing a cartridge before you see a message on the Epson Stylus NX400 Series LCD display screen, press Setup, select Maintenance, and press OK. Hello, Please use the following steps: 1.Turn on the printer If a cartridge is low or expended, you see a message on the Epson Stylus NX400 Series LCD display screen.
0 kommentar(er)
